ThermoQ
Programmable Incubator

Heat and Chill without Condensation

Now with a heated lid

Incubators should act as platforms to serve the varied needs of labs – compatible with many types of tubes or plates, capable of both chilling and heating, and performing multi-step functions. That is precisely what the ThermoQ Programmable Incubator offers. It boasts an interchangeable adaptor design and a built in heated lid. Allowing an extensive number of vessel types that can heat to 100°C or chill all the way to 4°C. The system can run independently for simple incubations or plug into your laptop or PC for multi-step programming. This means a single program can perform an enzymatic incubation, followed by heat inactivation and end with an ice cold hold until you are ready to retrieve your samples. The options are nearly limitless for this versatile incubator!


Tired of seeing the water in your sample condense at the top of the tube during an incubation? With its integrated heated lid, there is now no need to worry about evaporation loss in your sample due to condensation forming at the top of the tube. Go to lower volumes without worry. Your sample stays where it should, at the bottom of the tube, throughout your incubations!

 



LITERATURE
Instruction Manual
 
RELATED PRODUCTS
BioShake iQ
BioShake XP
ThermoE

 

 

 

Designed for today (and years to come)

Manufactured by one of the largest thermal cycler companies in the world, all Bioer sub-ambient incubators are powered by top-of-the-line thermoelectrics – from the world’s number one supplier of these heat pumps. With thousands of chiller incubators and thermal cyclers delivered to researchers across the globe, and a reliability rate in excess of 95%, you can trust in Bioer’s well-tested design principles. We do! And to prove it, every system comes with an industry-leading warranty that we stand firmly behind.

 

ThermoQ Attached To Laptop



SPECS
BITQ1baseHL
BITQ2baseHL
Temperature Range RT+5°C - 100°C 4°C - 100°C
Heating Time <10 min (RT-100°C) <8 min (RT-100°C)
Cooling Time N/A <8 min (100°C-4°C)
Heated Lid Yes
Temperature Uniformity +/- 0.5°C
Temperature Accuracy +/- 0.5°C
Maximum Steps 9 (when attached to PC)
Maximum Cycles 99 9 (when attached to PC)
Max Incubation Time 99 hours 59 minutes
Size 150 x 170 x 145 mm (LxWxH)
Weight 2.5 kg 3.0 kg
Power 90W AC, 100-240V, 50-60Hz 120W AC, 100-240V, 50-60Hz
Warranty 1-year


Heating Unit

ORDERING - BASE UNIT (Heating)

 

 

ORDERING - BASE UNIT (Heating & Cooling)

 

 

NOTE - You must chose a base type (above) and a block type (below) for a complete operational unit!

 

ORDERING - Block Type for BITQ1baseHL

 

 

ORDERING - Block Type for BITQ2baseHL